GS20 Series Water Pump Drive used on Constant Pressure Water Supply in Shanghai, China
Introduction
- Introduction
- Related Products
- Related Solutions
- Other Related Cases
- Additional Information
- Contact us
Project Introduction
Established in 2007, the Shanghai BY Hotel is a luxury five-star property offering 300 nature-view rooms, each ranging from 40 to 55 square meters, along with amenities including an indoor swimming pool, spa, fitness center, and a range of leisure facilities.
However, increasing occupancy and higher guest expectations exposed limitations in the original water supply system, which could not maintain consistent flow rates during peak morning and evening hours, leading to unstable water pressure.
The Solution:
To address this and support future growth, the hotel upgraded to two 11kW variable frequency pump units controlled by Veichi GS20 Series dedicated inverters. The system’s built-in constant pressure algorithm ensures stable water output by continuously adapting to pipeline demand. During periods of low usage, the pumps alternate operation to balance wear and extend lifespan. While when demand exceeds the capacity of a single pump, both units are activated automatically. Additionally, the smart sleep mode pre-pressurizes the pipeline before entering standby, which minimizes frequent starts and stops while further enhancing energy efficiency.

Project Products:
GS20 General Pump Drive
Voltage & Power Rating:
- 200V~240V / 0.75kW~55kW
- 380V~480V / 0.75kW~560kW
Output Frequency: 0Hz~599Hz
Overload Capacity: 150% rated current for 89s; 180% for 10s; 200% for 3s
Motor Type: Three-phase AM, PMSM, synchronous reluctance motor
Control Mode: V/F control, open-loop vector, closed-loop vector, and V/F separation
Modulation Method: PWM
Carrier Frequency: 1.0kHz~16.0kHz
Installation Conditions: Altitude <1000m (derate 1% per 100m above);
No leakage/ice/rain/snow/thunder;
Solar radiation <700W/m²
Atmospheric pressure 70kPa~106kPa Temperature: -10℃~+50℃(derating above 40℃)
Humidity: 5%RH~95%RH (non-condensing)
Vibration: 5.9m/s²(0.6G) between 9Hz~200Hz
Storage Temperature: -30℃~+60℃
Mounting Method: Wall-mounted
Protection Class: IP20
Protection: Over/under voltage, current limiting, overcurrent, overload, overheat, overvoltage stall, overspeed, I/O phase loss protection
Special Functions: Multi-pump control, pump sleep mode, pump clean, anti-freeze, soft pipe filling, low-speed protection, dry-run protection, inlet/outlet pressure protection

Global - English
Spanish - Español
Arabic - عربي
Italian - Italiano
Polish - Polski
French - Français
Russian - Pусский язык
Ukrainian - українська
Chinese - 中文
Korean - 한국어
Turkish - Türkçe
Vietnamese - Tiếng Việt